Before starting, let's prepare everything we need:
We will need them
- the essential liquids
- the 4 file in 1
- the brush
- the powder base powder
- the color
First let's get our file.
On this side we begin to mattify all our nails, after which we dust off the dust that will have been created.
We are ready to start our manicure and we will need the number one base coat product together with the powder base.
We proceed by applying a super thin layer of base coat.
Then we dip our finger inside the powder base.
We repeat the same procedure for all the other nails and wait just a few seconds.
After that we dust off the excess powder and move on to the color.
Here too we will have to apply a super thin veil of Base Coat.
Then dip the nail into the color we have chosen.
We repeat this step for all the nails. I am now in love with the sensation of dipping the nail into the powder on the ring finger. Instead I chose to apply this super sparkling glitter. After this phase I remove the excess powder.
Since I liked the Solar shimmer a lot, I also chose to do a French on the Medium. To do this, you just need to draw a small Bezel with the base coat.
Then dip the nail into the powder again.
After dusting off the excess powder.
We are at product number 2 activator. We also spread this over the entire surface of our nails,
After which we leave it on for 2 minutes, we take our file and go to mattify the entire surface of the nails.
After that we take the activator again, pass it through again and let it act.
For another two minutes we spread the third and final step Top Coat and here is the final result.
I really liked these colors and I'm sure that all nude lovers will like them.
I hope this tutorial was useful to you, let me know with a like or a comment and if you like, follow us so you don't miss the next videos.
✔️Do not use hand/nail care lotions before application, as the greasy surface reduces adhesion.
✔️ Make sure you only apply essential liquids to one nail at a time and immediately dip the nail into the powder before moving on to the next finger.
✔️ Apply only a thin layer of liquid at a time to avoid unwanted deformations or thickening.
✔️ Gently brush off excess powder after each use.
✔️ Take your time between individual steps to get the best possible result.
✔️ Respect the waiting times specified between Activator - Top Coat.
✔️ Apply a sufficient amount of Activator so that the powder adheres optimally and no air bubbles form at the edges. Don't forget the tip and edges of the nail.
✔️ Always wait until you have completed the entire coat before removing excess with the brush.
✔️ Close liquids immediately after use, to avoid the product solidifying.
✔️ Clean the applicators after each manicure, immersing them in the brush saver for approximately 15-20 minutes.